HomeProductsMachinesGuidesArticlesAboutReviewsSupport

Hayter Carburettor Parts

Hayter Carburettor Parts
Restore optimal fuel delivery and engine performance with genuine Hayter carburettor parts engineered for precise air-fuel mixture control across all operating conditions. Our comprehensive range of Hayter mower carburettor components includes complete rebuild kits, float assemblies, needle valves, main jets, gaskets, O-rings, and mounting hardware designed specifically for your engine model. Hayter lawn mower carburettor parts feature correct jet sizing, proper float specifications, and OEM-quality materials preventing fuel leaks and ensuring reliable starting. Compatible with Harrier 41, Harrier 48, Harrier 56, Spirit, and Ranger engines. Held in stock for immediate worldwide dispatch with rapid UK delivery available.
How to identify your Hayter Machine

Frequently Asked Questions

What components are included in a Hayter carburettor parts rebuild kit?
A complete Hayter mower carburettor rebuild kit typically includes float bowl gaskets, inlet needle valve and seat, float hinge pin, air cleaner mounting gaskets, O-rings for outlet ports and drain plugs, and various seals for throttle and choke shafts. These Hayter carburettor parts address common wear points where fuel leaks and air leaks occur. Always use complete genuine kits rather than reusing old gaskets, as carburetor cleaner residue will deform improperly cleaned gaskets causing immediate leaks after reassembly.
How do I clean Hayter lawn mower carburettor parts without damaging them?
Remove all non-metallic Hayter carburettor parts before cleaning, including gaskets, O-rings, and seals will decompose from carburetor cleaner exposure. Spray cleaner through all passages and jets, use small-gauge wire or paper clips to clear blocked openings, then blow compressed air through every passage. A critical step is to wash metal components in hot soapy water after chemical cleaning to remove all cleaner residue, rinse thoroughly, and blow dry with compressed air before installing new gaskets from your rebuild kit.
Can I adjust the fuel mixture on my Hayter lawn mower carburettor parts?
Modern Hayter carburettor parts are EPA-compliant and factory-set without external adjustment screws, and attempting modifications violates emissions regulations. Older non-EPA regulated models may have idle mixture and high-speed adjustment screws. If present, standard settings are: high-speed needle 1.5 turns out from seated position, idle mixture screw 1.25 turns out. However, normal maintenance like cleaning jets, replacing gaskets, and rebuilding with genuine Hayter carburettor parts remains acceptable and necessary for proper operation.
Why does fuel leak from the bottom of my Hayter mower carburettor?
Fuel leaking from the float bowl on Hayter lawn mower carburettor parts indicates either a stuck float needle valve allowing continuous fuel flow, a perforated float that has sunk preventing the needle from seating, or a deteriorated float bowl gasket. Remove the bowl, inspect the float for fuel inside by shaking it, clean the needle valve and seat with carburetor cleaner, and verify the float moves freely up and down. Replace the needle valve, float if damaged, and always install a new bowl gasket during reassembly.
What causes my Hayter carburettor to flood and spill fuel from the air intake?
A flooding Hayter mower carburettor results from the inlet needle valve failing to seal against its seat, allowing unrestricted fuel flow into the float chamber. Common causes include varnish buildup on the needle preventing proper seating, worn needle tip with grooves or nicks, corroded brass seat requiring replacement, or incorrect float level adjustment. Clean or replace Hayter carburettor parts as needed, then verify proper float height—when the carburetor is inverted, the float should sit nearly level with the carburetor body.